tue, 10-aug-2010, 06:07

Bathroom vinyl

Bathroom vinyl

We got all the flooring for the cabin on Sunday. We had planned on sheet vinyl for most of the areas that could get wet, but a remarkably helpful employee at Home Depot suggested we use “vinyl plank flooring” instead. It’s similar to laminate flooring in that it comes in pieces that fit together to form a solid, floating floor. In this case, the individual planks have top and bottom glue strips on the edges so that they stick to each other. The glue is pressure activated and once the pieces have been fused together, it’s waterproof. The stuff is also quite thick and stiff, so it’ll go right over variations and defects in the subfloor.

I did the bathroom installation last night. It’s difficult to get the seams completely tight, but when you’re not up close to the floor the variation in seams isn’t obvious. It’s also very difficult to cut, and I went through quite a few knife blades on this small room. Still, it’s much easier to install than getting a big sheet of vinyl to fit, and it’s so thick that it seems much more durable than even high quality vinyl.

We got two different tile patterns for the bathroom and entry area, and a simulated teak for the kitchen. The rest of the place gets laminate flooring in a simulated oak. It’s not really high quality stuff, but good enough for a rental and will look a lot nicer than the old carpeting I pulled up a month ago.

Meta Photolog Archives